|
Standard Sizes
Sizes available vary depending upon material used. Typical standard size is 48" x 96", maximum size is 60"
x 120" and is available only in selected patterns and materials.
Cutting and Forming
All
product is shipped with a PVC peal-away coating to protect the surface.
If proper care is exercised, this coating is adequate to protect
the surface while working with the material. Stainless, copper,
and brass sheets can be sheared and bent by traditional methods
with minimal to no disruption of the finish. Aluminum sheets can
be cut with saws equipped with sharp carbide tipped blades.
Adhesives
SpectraMetal can be applied with traditional contact adhesive or panel adhesive, or by mechanical
fasteners. Care should be taken not to get adhesive on the finished surface. If necessary, adhesive cleanup may be done with mild solvents such as naphtha or mineral spirits.
Cleaning and Care
Finished surface can be cleaned with mild soap and water and dried and buffed with a soft cloth. Harsh or
abrasive cleaners or solvents, or abrasive pads should not be used.
Storage and Handling
Material should always be transported and stored flat, on a fully supporting surface. Care should be
exercised when handling material to not scratch through the protective coating.
Process
SpectraMetal
is a unique patented procedure using a computer mapped mechanical
engraving process.
|
Specifications 
